Shelly 2.5
Shelly 2.5 is a smart Wi-Fi-operated switch, featuring two cannels and power metering. By default, it runs the Shelly proprietary firmware.
There is no power management support in the current espQToggle firmware.
Provisioning configuration name: espqtoggle/shelly/2.5.
- flash mode: DIO
- flash frequency: 40MHz
| Number | Function | Remarks |
|---|---|---|
| 0 | status LED | active low |
| 4 | relay 1 | active high |
| 5 | push button 2 | active low |
| 13 | push button 1 | active low |
| 15 | relay 2 | active high |
| Id | Type | Description | Range/Unit | Remarks |
|---|---|---|---|---|
push_button1 |
boolean | on/off button 1, setup button | ||
push_button2 |
boolean | on/off button 2 | ||
relay1 |
boolean | relay 1 | ||
relay2 |
boolean | relay 2 | ||
button_held |
button_held | button held status |
- a USB-to-serial adapter
- a laptop running Windows, Linux or macOS
-
⚠️ Do not power the device from mains! Do not connect it to AC at all during this procedure! -
Read the flashing instructions and be prepared to follow the flashing procedure.
-
Identify the RX, TX, GND, VCC and GPIO0 connectors:
-
Ensure the USB-to-serial adapter is not plugged into your laptop.
-
Connect the following USB-to-serial adapter wires to their corresponding connectors on the board: RX, TX, GND, VCC and GPIO0.
-
Plug the USB-to-serial adapter into your laptop, effectively powering the ESP chip on the board.
-
Follow the flashing procedure to flash the espQToggle firmware on the ESP chip.
-
Disconnect all wires.
You can now power your device by connecting it to mains. Follow the initial setup instructions to connect the device to Wi-Fi and add it to your qToggle system.