Arilux AL LC06
Arilux AL-LC06 is a smart LED strip controller with 6 channels. By default, it runs proprietary firmware.
Provisioning configuration name: espqtoggle/arilux/al-lc06.
- flash mode: DOUT
- flash frequency: 40MHz
| Number | Function | Remarks |
|---|---|---|
| 0 | setup button | active low |
| 2 | status LED | active low |
| 5 | cold white PWM | |
| 12 | green PWM | |
| 13 | blue PWM | |
| 14 | red PWM | |
| 15 | warm white PWM |
| Id | Type | Description | Range/Unit | Remarks |
|---|---|---|---|---|
push_button |
boolean | setup button | ||
pwm_freq |
number | PWM frequency | 0..50000 Hz | |
red_value |
number | red percent | 0..100 % | |
green_value |
number | green percent | 0..100 % | |
blue_value |
number | blue percent | 0..100 % | |
cold_white_value |
number | cold white percent | 0..100 % | |
warm_white_value |
number | warm white percent | 0..100 % |
- a soldering tool with accessories
- a set of wires to be temporarily soldered onto the board
- a USB-to-serial adapter
- a laptop running Windows, Linux or macOS
-
⚠️ Do not power the device! Do not connect it to the power supply at all during this procedure! -
Read the flashing instructions and be prepared to follow the flashing procedure.
-
Open the device:
-
Identify the RX, TX, GND and VCC connectors on the board:
-
Ensure the USB-to-serial adapter is not plugged into your laptop.
-
Connect the following USB-to-serial adapter wires to their corresponding wires soldered on the board: RX, TX, GND and VCC.
-
Ensure device will boot into bootloader mode by pressing and holding the button on the device.
-
Plug the USB-to-serial adapter into your laptop, effectively powering the ESP chip on the board.
-
You can now release the button.
-
Follow the flashing procedure to flash the espQToggle firmware on the ESP chip.
-
Disconnect all wires and reassemble the device.
You can now power your device by connecting it to mains. Follow the initial setup instructions to connect the device to Wi-Fi and add it to your qToggle system.