ADILOK for Raspberry PI

Introduction

This software receives train running and route set messages from the open data provided by Traffic Management Finland (CC BY 4.0). There is a bit register which the received messages modify as defined in the message rules. The contents of the bit register is send to shift-and-store circuits such as 4094. These ICs can control LEDs, relays etc.

Schematic Diagram

There can be any reasonable number of the shift-and-store registers.

RECV will blink always when a message is received. ACK will blink when a message which causes an action to be taken is received.

ERR is set before the first message is received or the previous message has been received over a minute ago. In this case, the socket will be reconnected.

Configuration

Configuration is a JSON file.

{
  "bits": 8,
  "initialPattern": "00000000",
  "rules": [{
      "station": "HKI",
      "action": "PULSE",
      "type": "OCCUPY",
      "bit": 0
    }
  ]
}

bits (mandatory) number of the controlled bits
initialPattern the state of the bits when the program is started, must be 0 or 1 - if missing or too short, zero will be used
rules see the definition in below

Rules

There can be any number of rules. Each rule must contain at least station, bit, and action. See all the possible rules in the list below.

station (mandatory) station code
bit (mandatory) bit number
action (mandatory) action to do, see the list below
type OCCUPY, RELEASE, ROUTESET, ROUTESET_C or ROUTESET_S
trackSection track section code
from previous station code
fromSection previous track section code
to next station code
toSection next track section code

In case of route set messages, previous and next station or section refers to the previous or next route section element in the route set message.

Types OCCUPY and RELEASE react to train running messages. Types ROUTESET, ROUTESET_C and ROUTESET_S react to route set messages. The last two types refer to cancelling a route or setting a shunting route.

Actions

AUTO OCCUPY message sets the bit, RELEASE clears
AUTOINV same as AUTO but inverted output
SET
CLEAR
PULSE gives a positive pulse, length ~100 ms
TOGGLE changes the current state to the opposite

Installation

Make sure that you have a recent version of Node installed:

curl -sL https://deb.nodesource.com/setup_8.x | sudo -E bash -
sudo apt-get install nodejs

Clone the repository:

git clone https://github.com/ttsirkia/adilok-raspberry.git

Move to the correct directory and install the required libraries:

npm install

Modify the configuration file and start the program:

node adilok-raspberry.js

The configuration file is by default read from the current directory. However, you can give any other config file as an optional parameter.

Debugging

Use the command line parameter --debug to start the program in debug mode. It allows to set and clear bits by giving the corresponding bit number.

You can also use --livedebug to start the normal mode together with the debug mode.

License

Do not use this software for any safety-critical purposes!

This software is licensed under the MIT license.

License

ttsirkia/adilok-raspberry

About

Resources

License

Uh oh!

Stars

Watchers

Forks

Releases

Packages 0

Uh oh!

Languages

Packages