bus-shinobi

Alternative to bus ninja running on Arduino Uno R3. Host communication via HW Serial of Arduino Uno: 9600-8-1-N

Commands supported:

• WD13?\n - Write Digital pin13 where:
  • ? is 'H' or 'L'
• WA$$?\n - Write PWM (Analog) signal to pin $$ with duty cycle proportional to ? where:
  • $$ is '09', '10' or '11'
  • ? is '0' to '9', '0' - duty 0%, '9' - duty 100%
• WHxxyz\n - Write Hexadicimal digit to segmented LED display (CA) where:
  • xx - digital pin number connected to segment A, can be from '02' to '06' next segments shall be connected to consecutive pins
  • y - is hexadecimal digit 0 - 9, A - F
  • z - when = '.' or ',' then dot is On
• RD08\n - Read state of Digital pin 8, response is RD08? where:
  • ? is 'H' or 'L'
• RAA0\n - Read Analog input of pin A0, response is RAA0xxxx where:
  • xxxx is ADC read in range 0 - 1023

See .\example folder for usage examples

Build

Project can be built with Sloeber, the Eclipse Arduino IDE - https://eclipse.baeyens.it/

ToDo:

• Add command support:
  • 1-Wire Tx/Rx (WO, RO)
  • UART Tx/Rx (WU, RU)
  • SPI Tx/Rx (WS, RS)
  • I2C Tx/Rx (WI, RI)
  • HD44780 display (WL)
  • N3310 display (WG)
• split arduino sketch into multiple source files
• support for RGB LEDs with common anode and cathode
• Check correctness of pin and duty values in CMD_analogParse()