This repo was created to develop a custom QMK firmware for the Epomaker EK68 with OpenRGB support.
However, I later rediscovered that the EK68 is a rebadged version of the Zuoya GMK67, which I had previously researched.
So instead of reinventing the wheel, I pivoted to adapting existing GMK67 firmware.
You can find the archived GMK67 OpenRGB firmware project here:
🔗 OdznArchives/OpenRGB-GMK67-Builds
OpenRGB-GMK67-Builds Old OpenRGB Builds with GMK67 support
- Set the mode selector to wired mode (not MAC or Windows wireless mode).
- Hold the
DELkey and insert the USB power cable to enter flash mode. - Flash the device using your preferred tool.
⚠️ Do not disconnect power until the process completes.
Flashing custom firmware is inherently risky.
It may void your warranty, damage your device, or cause unexpected behavior.
Proceed at your own risk.
I take no responsibility for any harm, data loss, or malfunction resulting from the use of this firmware or associated instructions.