| Supported Targets | ESP32-C6 | ESP32-H2 |
|---|
This code shows how to configure Zigbee router device and use it as HA CW light.
The ESP Zigbee SDK provides more examples and tools for productization:
- WT0132C6-S5 module acting as Zigbee router-device (loaded with this firmware)
- A CH340G-based programmer
Before project configuration and build, make sure to set the correct chip target using idf.py --preview set-target TARGET command.
Before flash it to the board, it is recommended to erase NVRAM if user doesn't want to keep the previous examples or other projects stored info using idf.py -p PORT erase-flash
Build the project, flash it to the board, and start the monitor tool to view the serial output by running idf.py -p PORT flash monitor.
(To exit the serial monitor, type Ctrl-].)
As you run the example, you will see the following log:
I (394) main_task: Calling app_main()
I (404) gpio: GPIO[8]| InputEn: 0| OutputEn: 1| OpenDrain: 0| Pullup: 1| Pulldown: 0| Intr:0
I (404) phy_init: phy_version 220,2dbbbe7,Sep 25 2023,20:39:25
I (464) phy: libbtbb version: 90c587c, Sep 25 2023, 20:39:57
I (474) ESP_ZB_COLOR_DIMM_LIGHT: ZDO signal: ZDO Config Ready (0x17), status: ESP_FAIL
I (474) ESP_ZB_COLOR_DIMM_LIGHT: Zigbee stack initialized
I (484) ESP_ZB_COLOR_DIMM_LIGHT: Start network steering
I (484) main_task: Returned from app_main()
I (9614) ESP_ZB_COLOR_DIMM_LIGHT: ZDO signal: NWK Permit Join (0x36), status: ESP_OK
I (9834) ESP_ZB_COLOR_DIMM_LIGHT: ZDO signal: NWK Permit Join (0x36), status: ESP_OK
I (9834) ESP_ZB_COLOR_DIMM_LIGHT: Joined network successfully (Extended PAN ID: 60:55:f9:00:00:f6:07:b4, PAN ID: 0x2a74, Channel:13)
I (32944) ESP_ZB_COLOR_DIMM_LIGHT: Received message: endpoint(10), cluster(0x6), attribute(0x0), data size(1)
I (32944) ESP_ZB_COLOR_DIMM_LIGHT: Light sets to On
I (33984) ESP_ZB_COLOR_DIMM_LIGHT: Received message: endpoint(10), cluster(0x6), attribute(0x0), data size(1)
I (33984) ESP_ZB_COLOR_DIMM_LIGHT: Light sets to Off
I (35304) ESP_ZB_COLOR_DIMM_LIGHT: ZDO signal: NLME Status Indication (0x32), status: ESP_OK
I (35534) ESP_ZB_COLOR_DIMM_LIGHT: Received message: endpoint(10), cluster(0x6), attribute(0x0), data size(1)
I (35534) ESP_ZB_COLOR_DIMM_LIGHT: Light sets to On
- GPIO pins 10 and 5 are used for PWM control of cold and warm white LED strips.
For any technical queries, please open an issue on GitHub. We will get back to you soon.