Installation.

1. Download and install NI labVIEW runtime 2020 32bit here.
2. Download and install NI visa runtime 2020 here. You don't need to install any addtional items leave everything as default.
3. Download and install the FTDI driver from here here
4. Finally download the evaluation software and unzip it here

How to use

1. Start with Hardware setup, select the used programmer "UART Board or SD4Yv01"
2. select the correct com port.
3. For SD4Yv01, click connect.

{width=75%}

4. Move to Device Selection and chosse the sensor.

{width=75%}

5. Move to Devive tab, depend on the selected device on the HW tab, you may have two "for dual die devices".
6. Select the desired configurations as shown in the image below

{width=75%}

4. To know more about the paramters and progamming steps, please read the datasheet

Supported devices

1. AS5161
2. AS5261
3. AS5162
4. AS5262

Supported programmers

1. UART Board >> User Manual
2. SD4Yv01 >> User Manual

To avoid errors

1. Make sure you followed the installation steps
2. Check the programmer link and go to downloads section for user guide.
3. Once you have the user manual, check the wiring, supply voltages and jumper connection if needed.