MAX10 Power Sequencer: Control 4 voltage rails via USB/PC and adjust on the fly from 0.8V to 3.3V, with up to 1A per rail. Perfect full automated voltage systems or laboratory, sequenced by MAX10. Includes a full PC controlled power demo, to Jump Start the board.
At the moment of writting this board is not being sold neither by Arrow nor from Trenz electronics. I got one of them as a free of charge Arrow promotion board in the European "JUMP START" Program for FPGAs.
-
Altera MAX10 8kLE FPGA (10M08SAU169C8G) (same FPGA as MAX1000)
- Total logic elements 8,064
- Total registers 105
- Total memory bits 387,072 (48 kB) [42 M9k]
- Embedded Multiplier 9-bit elements 48
- Total PLLs 1
- UFM blocks 1
- ADC blocks 1
-
1 clock at 12 MHz
-
7 user leds
-
4 DIP switches
-
1 user button
-
2 GPIOS
-
Programmer FTDI FT2232H-56Q
-
UART Serial Rx/Tx through USB (FT2232H)
-
1 ADC input (3V at 5.5V)
-
1 differential current input
- Analog DevicesAD8417BRMZ-RL SP Amp Current Sense Amp Single ±2.75V/5.5V 8-Pin MSOP T/R
-
Voltage input pin (VIN)
-
Voltage output pins (3.3V, 5V, USB_VBUS)
- 3V3 Intel / Altera EP5348UI Conv DC-DC 2.5V to 5.5V Step Down Single-Out 0.6V 0.4A
-
3 regulable output voltages (VDD1/2/3)
- VDD1 Intel / Altera EP53A7LQI Conv DC-DC 2.4V to 5.5V Step Down Single-Out 0.6V to 5V 1A
- VDD2 Intel / Altera EP53A7HQI Conv DC-DC 2.4V to 5.5V Step Down Single-Out 1.8V to 3.3V 1A
- VDD3 Intel / Altera EP5388QI Conv DC-DC 2.4V to 5.5V Step Down Single-Out 0.6V to 5V 0.8A