MantaE3EZ-HermitCrab2-CANBus-and-H2-V2S-Revo-Extruder-installation-on-Ender3Pro

Introduction

This repository details the installation process for the Manta E3EZ V1.0, Hermit Crab V2.0 CAN Bus, and H2 V2S Revo Extruder on Ender 3 Pro.

Before the hardware installation, you need to complete the Hermit Crab V2.0 CAN Bus software setup in this repository.

Table of Contents

1. H2 V2S Revo Extruder to Hermit Crab Tool Plate Installation
2. Hermit Crab V2.0 to Ender 3 Pro Assembly

Tools You May Need

During the installation, you will need the following tools to install the H2 V2S Revo Extruder to Hermit Crab V2.0:

• Flush Cutter
• Needle or Bent Nose Pliers
• Ferrule Crimping Tool Kit