This project enables remote control of a water pump based on two water level sensors (minimum and maximum), using LoRa communication between two ESP32 boards.
Esp32 and Lora RA-02 wiring
Transmiter sistem wiring
Receiver sistem wiring
🔧 Components 2 × ESP32 2 × LoRa RA-02 modules + adapter (with 3.3V regulator) 2 × Water level sensors (float or resistive) 1 × 5V Relay Module Power supply Jumper wires and breadboard
🧠 Operation The Remote ESP32 (sender) monitors water levels at the reservoir. It sends a signal via LoRa when either minimum or maximum level is reached. The Base ESP32 (receiver) receives the signal and activates/deactivates the water pump accordingly.
📡 LoRa CommunicationLevel Detected Signal SentMinimum LOWMaximum HIGH
🔌 Schematic Check the wiring diagram in docs/schematic.png.
🛠️ Setup Instructions Upload sender.ino to the reservoir ESP32. Upload receiver.ino to the pump controller ESP32. Power up the circuits. Use the serial monitor for debugging.
📜 License MIT License