Procedure to build multi image with mcuboot on Zephyr for i.MX RT1160 EVK

[vishnusudhan]

As i am new to this project , I am using i.MX RT 1160 EVK ,

where we can refer the detailed steps for multi-image build & flash with MCUBoot on zephyr for i.MX RT 1160 EVK? If its available share the link? I am also looking for the configuration , when we try to upgrade image over various method? like swap with out swap.

Also i have seen option in MCUBoot config like as below,

If i set this option as (number of upgrades) 2 , based on my understanding this option use to enable to upgrade the multi image with MCUBoot. is that correct? I am getting error as like below when i enabling this option . kindly clarify , how to config when we use to update the multi image with MCUBoot over WEST/JTAG or USB/UART.

cc: @danie007 & @tkmozhi

[DerekSnell]

Hi @vishnusudhan ,
I have not tried using MCUboot on the RT1160. But I do have steps posted at MCUboot and Zephyr on NXP i.MX RT series, which uses a similar RT MCU. I do not have experience with MCUboot's number of upgrades configuration. But the steps at this link show how to have two application images stored in Slot0 and Slot1, how to download a new image to Slot1, and how to swap them.

Best regards