Probe Module Addition for Boss/Circle OD Probing

[ZuuYork]

Hello!

Firstly, thank you so much for your wonderful software. I truly appreciate all of the hard work you've put into it.

If I could make one suggestion to be implemented, it's a "Probe Boss" sequence like you might find on a HAAS controller/machine. This would be extremely useful when using a 3D touch probe to locate the OD of a circular boss when doing operation 2, or just for probing in rough stock, It could have user inputs just like the "Hole Center" sequence where you input the diameter and a negative z offset to extend as far as needed for probing off the x and y surfaces.

I've attached a 1 min video showing the exact probing routine:

https://www.youtube.com/watch?v=CqC8iNMQGGw&ab_channel=WPIHaasTechnicalEducationCenter

Thank you for any chance of consideration, and have a great one!