Universal-G-Code-Sender to Lichuan EtherCAT CL3-E57H steper motor or ethercat servo motor

[dusan2819]

hi
at the moment have qwklaser lc1390 upgrade conversion to ethercat for Lightburn software and can use this
Universal-G-Code-Sender to Lichuan EtherCAT CL3-E57H steper motor or ethercat servo motor absolute encoder
control
if needed we can start crowed funding for development

thank you
dusan2819

[breiler]

I am not sure what you are asking.

UGS is not able to communicate directly with stepper motors, it needs a controller in between. So if you want to add support for closed stepper motors you will need to contact a controller firmware vendor.