Genmitsu 4040Pro error message

[Archer1968]

I am very new with CNC routers and have been attempting to set mine up. I am using UGS and when I start it up and connect, I get an error message- "Error while processing response : An unexpected command was completed by the controller."
I looked thru the previous posts and could not find a post in regards to this error.

Right from when I connect, it says [MSG:Check Limits]
and then the error messsage.

Does anyone have a direction for me to go to resolve this?

[breiler]

Make sure that the limit switches aren't engaged when you power on your machine.

[Archer1968]

How do I disengage them prior to power up? Is this a software setting or do I unplug them?

…

On Mon, Apr 21, 2025 at 8:24 AM Joacim Breiler ***@***.***> wrote: Make sure that the limit switches aren't engaged when you power on your machine. — Reply to this email directly, view it on GitHub <#2763 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/BRWGTBU2GQAITYQFTIRJEWD22ULVDAVCNFSM6AAAAAB3RPEXEWVHI2DSMVQWIX3LMV43URDJONRXK43TNFXW4Q3PNVWWK3TUHMYTEOJQGA2DONA> . You are receiving this because you authored the thread.Message ID: <winder/Universal-G-Code-Sender/repo-discussions/2763/comments/12900474@ github.com>

-- James Rollo 907.687.8978

[breiler]

Just move the gantry manually