Conectar a placa MKS DLC32 v2.1 a universal g-code sender

[Gabriel28Anselmo]

@breiler boa tarde como esta?
Breiler, tenho a placa MKS DLC32 v2.1 e hoje utilizo o software LigthBurn para ler e executar os meus arquivos G-code.
porem, estou sentindo necessidade de migrar de software do LightBurn para o Universal G-code Sender Platform.
a minha placa MKS DLC32 v2.1 possibilita conexão via wifi e porta com. porem nao estou conseguindo conectar o software UGS à placa.
configurei instruções que você mencionou para o outro colaborador do grupo
https://github.com/winder/Universal-G-Code-Sender/wiki/Connecting-the-Controller#smoothie

fiz e porem não consegui conectar a placa

utilizo o grbl como firmware
e tenho a opção de conexão via wifi e porta usb
consegue me dar uma ajuda?
sou o Gabriel Anselmo desenvolvedor iniciante aqui do Brasil

desde já agradeço

[Gabriel28Anselmo]

[breiler]

Start by connecting to it from USB, what is the console output when you try to connect to it?

[Gabriel28Anselmo]

com12

[breiler]

Are you saying that this window only writes com12?

[Gabriel28Anselmo]

essas são as opções que tenho na configuração

[breiler]

There are so many errors with your settings...

Start with connecting to it using USB serial to make sure that UGS can talk with the board.

• Select the connection driver JSerialComm
• Select the firmware GRBL (I assume that it is installed on your board and not Smoothieware)
• Select the port in the drop down (you mentioned COM15 earlier)
• Set the baud to 115200
• Connect to the board
• Copy and paste the output from the console here

[Gabriel28Anselmo]

*** Connecting to jserialcomm://COM12:115200
*** Fetching device status

?
buffsize:243
<Idle|MPos:0.000,0.000,0.000|Bf:63,243|FS:0,0|Pn:PXYZ>
ok
*** Fetching device status (2 of 3)...
?
buffsize:243
<Idle|MPos:0.000,0.000,0.000|Bf:63,243|FS:0,0|Pn:PXYZ>
ok
*** Fetching device status (3 of 3)...
?
buffsize:243
<Idle|MPos:0.000,0.000,0.000|Bf:63,243|FS:0,0|Pn:PXYZ>
ok
**** Connection closed ****

[Gabriel28Anselmo]

[breiler]

All the settings looks correct and you are getting some correct responses from the controller
except for the "buffsize:243" which is not a part of the GRBL protocol and will prevent you from using UGS.

I looked through the code of the MKS firmware and couldn't find any reference of "buffsize":
https://github.com/makerbase-mks/MKS-DLC32-FIRMWARE/tree/main/Firmware

I can't help you with this board.