You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
New to UGS, I can't find a way to enable the laser on low power while running Outline to check the positioning of a pc board. Running UGS 2.0.7 on raspberry pi 4b 8G. All appears ok so far.
thank you in advance
David
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
Uh oh!
There was an error while loading. Please reload this page.
-
New to UGS, I can't find a way to enable the laser on low power while running Outline to check the positioning of a pc board. Running UGS 2.0.7 on raspberry pi 4b 8G. All appears ok so far.
thank you in advance
David
Beta Was this translation helpful? Give feedback.
All reactions