Cameras never go to idle

[PhilipMGio]

Cameras stuck on streaming wich drain battery. Vmc4030.

[twrecked]

We don't start streams unless asked to, can you send me some debug so I can see what is going on? Thanks

…

On Tue, Jan 7, 2025, 15:44 PhilipMGio ***@***.***> wrote: Cameras stuck on streaming witch drain battery — Reply to this email directly, view it on GitHub <#1027>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ALHJU6WV22GCYVBXUSNAWVT2JQ4BZAVCNFSM6AAAAABUYPSRT2VHI2DSMVQWIX3LMV43ASLTON2WKOZSG43TGNZQGE4DOMI> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

[PhilipMGio]

Yes you are right, i start a stream then close the window feed. But the condition never goes to idle it is stuck att streaming unless i maually force it to idle.

How do i send you debug?

[twrecked]

This may be something I can look at. Is this the Lovelace component?

…

On Tue, Jan 7, 2025, 15:55 PhilipMGio ***@***.***> wrote: Yes you are right, i start a stream then close the window feed. But the condition never goes to idle it is stuck att streaming unless i maually force it to idle. How do i send you debug? — Reply to this email directly, view it on GitHub <#1027 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ALHJU6TTHAM7D2DR5XM662L2JQ5KXAVCNFSM6AAAAABUYPSRT2VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDKNZWGIYDENBXGI> . You are receiving this because you commented.Message ID: ***@***.***>

[PhilipMGio]

Yes, thanks. Everthing else is working flawlessly.

[RadDip]

I can confirm this also happens with my older VMC3030 with the latest Coe update of 2025.1.1 fro yesterday on Arlo firmware 0.8.1.11. Was fine prior.

[RadDip]

Just an FYI… I had a streaming error for that specific camera that showed up in my logs. I accidentally cleared my logs trying to copy and paste that into this forum so you could see it. For some reason, I cannot find it in the raw logs. But, it was something like a stream error being initiated and I did not stream the camera. If it shows up again, I will paste it here.

[coreym95]

I did a couple of things to combat this. I added a button on my cameras page to stop streaming. I also added an automation that will stop streaming if any of the cameras were steaming for 2 minutes.

[twrecked]

I never did ask, which lovelace card are you using to stream?