Add support for PowerSeries Neo

[ghost]

hi, i received today Dsc PowerSeries Neo (https://www.dsc.com/dsc-product-families/Neo/1), and tested with current firmware, as expected, it's not working...
question, it,s possible to add support for this model?
i can send to firmware developers, dsc panel to reverse new protocol. Best regards
dsc neo screens:

[taligentx]

Hi @connected201 - please refer to the README.md, this has already been addressed. Neo uses a totally different encrypted protocol so unless someone is able to crack the encryption these systems cannot be directly interfaced.

[PascalSI]

Hi @connected201 , where can i see how you made a printed circuit board for such a case?

[ghost]

hi @PascalSI , i wil made some changes, and add gsm support , and i will public all sources

[ArduinoQ97]

@connected201 Hi.
Just wondering whether you manage to find a way to use connect to Neo series?
@taligentx Do you have any update on Neo series or any advice on how can to connect with them?
Thanks

[taligentx]

Hi @ArduinoQ97 - no news on the Neo series, the protocol would need to be decrypted by someone.

[fariddergal]

Hi all , any news about neo interface? Thanks

[taligentx]

Hi @fariddergal - no news on the Neo series, the protocol would need to be decrypted by someone.

[fariddergal]

There is a communication board tl280e I have read that it comunícate a with the main board through tp Link, I have read in the specification that it can be configured to un able the encryption locally , the ñoint is to see if any developer is putting his eyes on this topic otherwise will be very hard

[fariddergal]

There is a communication board tl280e I have read that it comunícate a with the main board through PC Link, I have read in the specification that it can be configured to un able the encryption locally , the ñoint is to see if any developer is putting his eyes on this topic otherwise will be very hard