Bosch CLC8001i

[roboticsalign]

Dear all,

Thanks for this great project.

I am trying to get a Bosch CLC8001i connected, but the board seems to be different:

CN70 has +5V and GND on pins 0 and 7 and can power the esp. But do you have a recommendation, where RX and TX could be located or how I could search them?

[sven819]

That seems to be a different version of the board, but as far as I know, the CL8000 series also uses the G10 CL-2. Looking at the third-party module from WiHeat on this page the pin assignment appears to match. Please let me know if this is the case so I can include it in the README. The init log might also provide some insight, especially for identifying unknown bytes, since this is a different version. If everything matches, please provide the init log.

Edit:

CN70 seems to be the wrong connector; it should be CN13A

[sven819]

CN70 seems to be the wrong connector; it should be CN13A

[roboticsalign]

thanks. I'll give it a try, when I'll get the source code compiled...

[roboticsalign]

It seems, that I have a different one. The Wifi module is connected to BCN13 and seems to have a different configuration. Pin 1 seems to be GND and Pin 4 +5V. But the other Pins do not provide data on RX at ESP side. Do you have a recommendation, how to analyze the pins?

[roboticsalign]

Well, I just had a bad connection at PIN3... So I can confirm, that it connects with:
Pin1 (red): GND
Pin2: RX
Pin3: TX
Pin4: 5V

The behavior is different to my Buderus device with a CN13A pin. I'll do some more research on that and post the init sequence later.

[roboticsalign]

I'll get the following init data. Esp is not recognizing, that it is switched off, but the switch command seems to work. Than I can start heating again. Plasmacluster is not recognized by esp. I cannot check, if the command is working.

... Connected successfully
19:58:10
[safe_mode:041]
Boot seems successful; resetting boot loop counter
19:58:10
[esp32.preferences:114]
Saving 1 preferences to flash...
19:58:10
[esp32.preferences:143]
Saving 1 preferences to flash: 0 cached, 1 written, 0 failed
19:58:10
[sharp_ac.climate:059]
NEW CONNECTION
19:58:10
[ac_frame:080]
Sharp INIT Data: 02.FF.FF.80.00.00.0A.01.00.D0.00.00.05.01.30.00.01.70 (18)
19:58:10
[ac_frame:080]
Sharp INIT Data: 02.FF.FF.81.01.00.00.80 (8)
19:58:10
[ac_frame:080]
Sharp INIT Data: 06
19:58:10
[ac_frame:080]
Sharp INIT Data: 03.FF.00.01.6D.00.00.93 (8)
19:58:10
[ac_frame:080]
Sharp INIT Data: 06
19:58:10
[ac_frame:080]
Sharp INIT Data: 03.FE.00.01.07.07.03.03.07.00.01.06.04.04.00.00.D7 (17)
19:58:10
[ac_frame:080]
Sharp INIT Data: 06
19:58:10
[ac_frame:080]
Sharp INIT Data: DC.0B.FC.72.1A.21.F8.00.10.00.00.00.00.44 (14)
19:58:10
[climate:396]
'EG Wohnzimmer Klimaanlage' - Sending state:
19:58:10
[climate:399]
Mode: HEAT
19:58:10
[climate:404]
Fan Mode: AUTO
19:58:10
[climate:410]
Preset: NONE
19:58:10
[climate:416]
Swing Mode: HORIZONTAL
19:58:10
[climate:419]
Current Temperature: nan°C
19:58:10
[climate:425]
Target Temperature: 26.00°C
19:58:10
[select:015]
'Horizontal Vane': Sending state swing (index 0)
19:58:10
[select:015]
'Vertikal Vane': Sending state auto (index 0)
19:58:10
[switch:055]
'Plasmacluster': Sending state OFF
19:58:10
[ac_frame:080]
Sharp INIT Data: 06
19:58:10
[ac_frame:080]
Sharp INIT Data: DC.0F.FD.72.12.00.00.1C.65.26.65.00.00.00.40.1D.4F.B8 (18)
19:58:10
[climate:396]
'EG Wohnzimmer Klimaanlage' - Sending state:
19:58:10
[climate:399]
Mode: HEAT
19:58:10
[climate:404]
Fan Mode: AUTO
19:58:10
[climate:410]
Preset: NONE
19:58:10
[climate:416]
Swing Mode: HORIZONTAL
19:58:10
[climate:419]
Current Temperature: 28.00°C
19:58:10
[climate:425]
Target Temperature: 26.00°C
19:58:10
[select:015]
'Horizontal Vane': Sending state swing (index 0)
19:58:10
[select:015]
'Vertikal Vane': Sending state auto (index 0)
19:58:10

[ac_frame:080]

Sharp INIT Data: 06

19:59:09

[ac_frame:292]

Sharp Frame Data: 06

19:59:09

[ac_frame:292]

Sharp Frame Data: DC.0F.FD.72.12.00.00.1C.65.26.1A.00.00.00.40.1D.4F.03 (18)

19:59:09

[climate:396]

'EG Wohnzimmer Klimaanlage' - Sending state:

19:59:09

[climate:399]

Mode: HEAT

19:59:09

[climate:404]

Fan Mode: AUTO

19:59:09

[climate:410]

Preset: NONE

19:59:09

[climate:416]

Swing Mode: HORIZONTAL

19:59:09

[climate:419]

Current Temperature: 28.00°C

19:59:09

[climate:425]

Target Temperature: 26.00°C

19:59:09

[select:015]

'Horizontal Vane': Sending state swing (index 0)

19:59:09

[select:015]

'Vertikal Vane': Sending state auto (index 0)

20:00:08

[ac_frame:292]

Sharp Frame Data: 06

20:00:08

[ac_frame:292]

Sharp Frame Data: DC.0F.FD.72.12.00.00.1D.65.26.1A.00.00.00.40.1D.4F.02 (18)

20:00:08

[climate:396]

'EG Wohnzimmer Klimaanlage' - Sending state:

20:00:08

[climate:399]

Mode: HEAT

20:00:08

[climate:404]

Fan Mode: AUTO

20:00:08

[climate:410]

Preset: NONE

20:00:08

[climate:416]

Swing Mode: HORIZONTAL

20:00:08

[climate:419]

Current Temperature: 29.00°C

20:00:08

[climate:425]

Target Temperature: 26.00°C

20:00:08

[select:015]

'Horizontal Vane': Sending state swing (index 0)

20:00:08

[select:015]

'Vertikal Vane': Sending state auto (index 0)

20:01:08

[ac_frame:292]

Sharp Frame Data: 06

20:01:08

[ac_frame:292]

Sharp Frame Data: DC.0F.FD.72.12.00.00.1E.65.25.19.00.00.00.40.1D.4F.03 (18)

[roboticsalign]

Current Temperature seems to be unplausible:

20:12:15
[ac_frame:292]
Sharp Frame Data: 06
20:12:15
[ac_frame:292]
Sharp Frame Data: DC.0F.FD.72.12.00.74.20.65.22.00.00.00.00.40.1D.4F.A9 (18)
20:12:15
[climate:396]
'EG Wohnzimmer Klimaanlage' - Sending state:
20:12:15
[climate:399]
Mode: HEAT
20:12:15
[climate:404]
Fan Mode: AUTO
20:12:15
[climate:410]
Preset: NONE
20:12:15
[climate:416]
Swing Mode: HORIZONTAL
20:12:15
[climate:419]
Current Temperature: 0.00°C
20:12:15
[climate:425]
Target Temperature: 26.00°C
20:12:15
[select:015]
'Horizontal Vane': Sending state swing (index 0)
20:12:15
[select:015]
'Vertikal Vane': Sending state auto (index 0)

After a while it becomes plausible again:

20:15:08
[ac_frame:292]
Sharp Frame Data: 06
20:15:08
[ac_frame:292]
Sharp Frame Data: DC.0F.FD.72.12.01.DD.17.04.28.1B.00.00.00.40.1D.59.7E (18)
20:15:08
[climate:396]
'EG Wohnzimmer Klimaanlage' - Sending state:
20:15:08
[climate:399]
Mode: HEAT
20:15:08
[climate:404]
Fan Mode: AUTO
20:15:08
[climate:410]
Preset: NONE
20:15:08
[climate:416]
Swing Mode: HORIZONTAL
20:15:08
[climate:419]
Current Temperature: 23.00°C
20:15:08
[climate:425]
Target Temperature: 26.00°C
20:15:08
[select:015]
'Horizontal Vane': Sending state swing (index 0)
20:15:08
[select:015]
'Vertikal Vane': Sending state auto (index 0)