Blank / Hung loading a page in CP

[nickcoppins]

Hi,

I'm new to Statamic, looking at migrating our existing long term Laravel site.

I've setup a test site and installed the Peak starter kit as well as some page builder blocks and a preset.

I appear to be encountering an issue when having created a test page (which works fine to start with) by adding a block (not sure if it's a specific block at this point or not) and then trying to access it again in the CP, it just loads a blank page / doesn't load the page for editing at all.

Should I install the debug bar to get more info? Unsure the best way forward to debug what's going on.

UPDATE: I enabled the debug bar and even it doesn't load on the page in question.

[duncanmcclean]

Try running php artisan statamic:install - does that help at all?

[nickcoppins]

That seemed to install OK, but didn't change anything.

The page that is loading blank only contains the source / HTML below: