v1.2.0

[Sergio5714]

The release v1.2.0 of the WULPUS platform includes the following changes:

Added

• Fabrication instructions for the WULPUS silicone package (refer to WULPUS User Manual Rev. 2).
• Source design files for the WULPUS silicone package (/hw/wulpus_silicone_package).
• Updated repository description and an expanded list of contributors in README.md.
• Added new publications utilizing the WULPUS probe to README.md.

Fixed

• Resolved multiple inaccuracies in WULPUS User Manual Rev. 1 (questions for using the gui for measuring A-mode and B-mode data #13, Mating connector and pre-crimped wires #15, Missing .epf File in Step 6 of Setup Instructions in page 16 of 2.3.2 Flashing the device(user manual) #18, User guide corrections #22).
• Fixed issue Power supply spikes exceeding the resistors power rating. Enable pin control of the U1 #17: Power supply spikes exceeding resistor power ratings. Added enable pin control for U1 of Acquisition PCB.
• Addressed issue Missing ground plane for microstrip #21: Improved antenna layout for better performance.
• Updated acquisition PCB layout and production files accordingly.

Changed

• Replaced chip antenna on the Acquisition PCB and updated the matching circuit.

Removed

• Removed mounting hole on the Acquisition PCB to allow for RF routing and antenna matching network adjustments.

---

This discussion was created from the release v1.2.0.