Details for 3D Printed Parts

[brightsnowzhao]

Hi, is there an instruction on recommended 3D printing parameters? I'm looking for the proper layer height and infill rate. I tried 0.2mm and 15% to print the servo cage. It looks OK except that the nut holes appear to be too loose and the nut can rotate inside. I had to use a pin to hold it in order to tighten.

[brightsnowzhao]

Quick update - I've tried a few settings and found that 0.2mm with 15% to 20% filling is good. The parts are solid enough and fine enough. It appears to be related to the quality of the printer. I start to get worried about the quality when the layer height was increased to 0.3mm. I'm printing all the parts at 0.2mm now.

[palanc]

Hi @brightsnowzhao - Sorry for not replying sooner, and thank you for sharing settings that have worked for you! We've had success with similar settings (0.2mm layer height, 20-25% infill).