{"code":"key61, "msg":"Unknown command:M205", "values": ["M205"]}

[Shootingblanks00]

I am brand new to Klipper So please bear with me.
Printer: Ender 3 S1 Plus,
Sonic Pad ( just got it last week),
Creality Nebula Camera,
Cura 5.10.1 ........Everything is current.
I am getting that error but it does not stop printing. I did have timelapse turned on and then I turned it off. When I am printing, the console keeps displaying that error over and over. I have searched through all of the config files but cannot find the M205 anywhere. I do not have any macros set. I do not have the M205 in my start Gcode. Once I got everything up and running I haven't had any issues other than that repeating message. That Gcode has something to do with movement and I haven't gotten smart enough to figure out what the movement might be.
Any ideas?
Thank you.

After reading a post I found just now, it may be because I do not have Acceleration Control checked. I unchecked it after watching "Slicer Settings and Profiles With Cura - Sonic Pad Intermediate Part 3" https://www.youtube.com/watch?v=Aqi5vjE0_QU&list=PLC4bOo0vesmLKXC2iWGTRBbbjXiHDj3Xz&index=3

I'm in the middle of printing something so I will work withe the settings in Travel in Cura.