Startup Process

To startup up the InsteonPLM module create a call to insteonplm.Connection.create. Ideally this is wrapped in an asyncio loop. A simple startup example would be:

import asyncio
import insteonplm


@asyncio.coroutine
def start_insteonplm(loop):
    connection = yield from insteonplm.Connection.create(
            device='/dev/some_device',
            loop=loop)


loop = asyncio.get_event_loop()
asyncio.ensure_future(start_insteonplm(loop))
loop.run_forever()

insteonplm.Connection.create returns a Connection class and accepts the following parameters:

• device: path to the USB or serial port where the PLM device is attached. The default is '/dev/ttyUSB0'
• host: Host name or IP address of a Hub. If this parameter is set, the module assumes the Insteon Modem is a hub even if the device parameter is set above.
• port: IP port number for the Hub connection. Default is 25105.
• username: Username of the local Hub connection.
• password: Password of the local Hub connection.
• auto_reconnect: Boolean value to tell the Connection class to reconnect if the connection is lost
• loop: asyncio loop.
• workdir: Working director to store the device information found during startup. If this value is set a file will be saved in this directory called insteon_plm_device_info.dat. This file will be read on subsequent startups to improve startup time.
• poll_devices: Boolean value to tell the Insteon Modem to poll the device status.