Error when creating front ports #12615
-
|
Hi there, However, when I do this, and hit "create" I get the following error: When I try and create a single front port (e.g. "Vorne1") that works without a problem. Any idea what I'm doing wrong? Thanks!! |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
It's a bug in Netbox that it barfs with an exception, it should give you a more friendly error. But I think you'll need to select all 24 rear ports into the box labelled "rear ports", since you created 24 separate rear ports (and presumably you selected each rear port has having 1 position). i.e. Hinten1:1, Hinten2:1, Hinten3:1 etc The other way to do this is to create 1 rear port with 24 positions, and then you would select the 24 positions of the same rear port, i.e. Hinten1:1, Hinten1:2, Hintent1:3 etc. That's if you want to run a single cable (like an MPO cable) to a similar ODF with 1 rear port and 24 front ports. |
Beta Was this translation helpful? Give feedback.
-
|
Thanks! Yes - that seems to have fixed the problem. |
Beta Was this translation helpful? Give feedback.
It's a bug in Netbox that it barfs with an exception, it should give you a more friendly error.
But I think you'll need to select all 24 rear ports into the box labelled "rear ports", since you created 24 separate rear ports (and presumably you selected each rear port has having 1 position). i.e. Hinten1:1, Hinten2:1, Hinten3:1 etc
The other way to do this is to create 1 rear port with 24 positions, and then you would select the 24 positions of the same rear port, i.e. Hinten1:1, Hinten1:2, Hintent1:3 etc. That's if you want to run a single cable (like an MPO cable) to a similar ODF with 1 rear port and 24 front ports.