Topology View show both connection-types for same interfaces

[Frank17489]

Hi,

here some cases, they I don't understand.

1. I have a cable connect between 2 switches.
   the access-switch sa01 is a stack with more switches (sa01.1,a sa01.2,....) . The first of this stack (as01.1) is marked as master and shows all interfaces of the stack.

as01.1 interface 1/50 is direct connected to core01
as01.2 interface 2/50 is connected via many patchpanels (FP/RP...) to core02
in topology view I see sa01.1 with a logical connection and a cable. But both goes to the same end interfaces.
as01.2 is displayed as single extra switch with logical connection

I configure a LAG and put both interfaces to this. But the view give the same picture.

Update: both cable types are displayed when I select "Show redundant Cable and Logical Connection"

2. the parts of another stack are also displayed as a single switch ( but with correct logical connection )