.NET nanoFramework
Why i can't use bluetooth scanner sample in samples repository? #1266
Replies: 3 comments 5 replies
-
|
Are you sure that you have a Revision 3 ESP32 hardware?. How about try to load ESP32_BLE_REV0 firmware? |
Beta Was this translation helpful? Give feedback.
-
|
@alberk8 But project run and i found devices and id's just localName is Empty |
Beta Was this translation helpful? Give feedback.
-
|
@alberk8 with that REV0 is still not show me |
Beta Was this translation helpful? Give feedback.
-
|
Are you using the Bluetooth Sample code or your own code. Try this sample code |
Beta Was this translation helpful? Give feedback.
-
|
This is bad news about this!!! |
Beta Was this translation helpful? Give feedback.
-
|
It could be your module antenna is not good. I have tested on my module and it works. |
Beta Was this translation helpful? Give feedback.
-
|
Did you use an ESP32 with the UFL connector like this one? In that case you need at least a pigtail in order to find other devices with wifi/bluetooth |
Beta Was this translation helpful? Give feedback.
-
|
no i just use onboard bluetooth ESP32 WROOM Wifi Bluetooth |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
when i wana to use that with ESP32_BLE_REV3 firmware version i dont see device names and device names is empty how can i solve that problem?
Beta Was this translation helpful? Give feedback.
All reactions