implementation of a pressure sensor

[luckbert]

Hello all,
I am currently trying to switch my home automation from FHEM to Homeassistant.

It fails just at the implementation of a pressure sensor in the drain pipe. It reports if there is a backwater or not.
It is my only enocean device.
I am overwhelmed with setting up a new device and need help. In the best case ready files that I just insert.
I could already find the ID and the EEP herrausfinden.
ID: 05:18:9A:52
EEP: A5-30-04

I hope that you can help me.
Greetings Juergen

[mak-gitdev]

Hi @luckbert,

What is the reference of your device ?

[luckbert]

Sorry, I don't understand the question.
What do you mean by reference?

[mak-gitdev]

@luckbert,

I mean which device is it ? Manufacturer ? Name ? ...

[luckbert]

The device is manufactured by "Kessel". And is called "Staufix Control". The only data I could find is, see attachment. Grüße Jürgen  Screenshot from FHEM 

[mak-gitdev]

@luckbert

A5-30-03 and A5-30-04 will be available in the next release.

Follow

[luckbert]

Mega cool,
Thanks a lot!

[mak-gitdev]

Done in 0.1.27

[luckbert]

Hello,
I tried to add the sensor today. Unfortunately this did not work. The sensor is not paired with any device. (According to the flashing sequence of the sensor).
HA_enoceanmqtt is in learn mode.
In the log it says anyway
"2023-10-23 09:47:33,998 INFO: unknown sensor: 05:18:9A:52

What am I doing wrong?

[mak-gitdev]

Hi @luckbert,

Did you add the sensor in your device file ?
Please have a look at this wiki page for more details.

Please feel free to make comments if something in the procedure is not clear.

Thanks.

[luckbert]

Good evening,
The problem was on me. I have a repeater to increase the range.
I had to bypass it for the setup and turn it off and be closer to the sensor.
Now it seems to work.

Thanks again for the support

Greetings Juergen