How to ? any need ?

[luc-github]

I would like to add some How To? Any suggestions ?

[DivingDuck]

Some ideas:
Maybe something like how to connect a specific board to an specific controller board and how to get it running. Some information's for hardware are already there but I think most of potential users have problems to get it running from setup perspective.

Other howto's are maybe something like how can someone integrate additional sensors, custom extensions, buttons etc.

[luc-github]

@Overnuts I do not have all hardware so I may not be able to cover all how to like this

If you have issue to setup, I think the best is first to open question to describe your setup issue / question, then we can work on solving it, once solution is found - a clear how to can then be done

[luc-github]

did you checked : https://www.youtube.com/watch?v=Z5Cnm-1ybFY
and https://www.youtube.com/watch?v=NGgzw-XayEo
both explain Marlin setup for SKR Pro - I do not know what you use on your MPCNC

[DivingDuck]

@luc-github Yes, that came into my mind.

[Overnuts]

@Overnuts I do not have all hardware so I may not be able to cover all how to like this

If you have issue to setup, I think the best is first to open question to describe your setup issue / question, then we can work on solving it, once solution is found - a clear how to can then be done

Hi, I understand, you can't have all devices !
I found a few explanations here (fr) https://www.civade.com/post/2020/09/22/Ajouter-le-support-du-Wifi-sur-une-imprimante-3D-fonctionnant-avec-Marlin-2
At the end of the page "fixup" part
I should try this, and let you know, or there is a way to do in the setup ?
Do you want me to add an issue to ask for a parameter like "on boot, wait xx seconds" ?

[luc-github]

@Overnuts but as you see in fixup, this parameter already exists in 2.1 myesp3d.begin(15000); // jpc wait 15 seconds
in 3.0 there is a command and setting to change it without recompiling