FLY board requires 2 pin jumper pins

[TheOnlyMann]

https://teamgloomy.github.io/fly_e3_pro_v3_general.html
according to this, since we are only using 1 z motor, we need a jumper pin installed on the other z.
same goes for the diag pins as we utilize sensorless homing for the most part

[Chuckles182]

What would the correct wiring be? There are four stepper motors, is one of them driven from E0 or E1?
C axis = ?
Z axis = Z1
X and B axis motors = ?

[jyjblrd]

@Chuckles182 its arbitrary, and set in the config. Eg:

M584 C0 Z4 X1 B2 E3 S0  

C is drive 0, Z is 4, etc.

[TheOnlyMann]

@Chuckles182 its arbitrary, and set in the config. Eg:

M584 C0 Z4 X1 B2 E3 S0  

C is drive 0, Z is 4, etc.

one thing to check, did you install the jumper pins? if you did i wonder what sizes they are, the wiki doesnt seem to state and there seems to be 2 types, 2.54mm and 2.00mm

[xobes]

My board came with 5 jumpers -- 2.54 (0.1 in) jumpers. I happen to have a treasure trove of these in my electronics parts, too.