reprap firmware config

[iyxx37]

reprap firmware config , this is all of firmware config ? or this is just part of firmware config? and should i add this firmware config into the original firmware config that the main board already have it when sell

[ZiiB]

RRF has a specific folder architecture, extensively explain in its wiki.
Basically, you configure the firmware to your needs, past the .bin file at the root of the SD card, and copy every file provided in sys folder of the project in the sys folder on your SD card.
If you are using the same motherboard as BOM, it should be it.

[oldnslow]

@iyxx37 you may find some of your questions answered and a little more detail about how to perform an initial install and setup of the RRF in this Core-R-θ Wiki section on Fly E3 Pro V3 setup. The guide explains how to use the Team Gloomy documentation and the firmware configuration files for the Core-R-θ to determine how the drives and fans are mapped.

Note the wiki needs updating, refer to to4axis.g in the section on drive mapping if using the printer in non-planar 4 axis (normal Core-R-θ XZBC mode i.e. output of S4 slicer) and topolar.g if using printer in conventional XYZ mode (i.e. conventional slicer output).

The Fly E3 Ultra setup should be the same, however be sure to access the Team Gloomy Fly E3 Pro Ultra pages vs the Pro V3 pages.

Also note, if you are getting a Fly E3 Ultra, be sure to also order the Esp32 Board For RRF option as well in order to have ethernet/wifi connectivity if you intend to run headless operation via Duet Web Control which is recommended.

[the-Geeson]

So, going through this guide, its stats that the heated bed is disabled, What do I need to change to enable it?

[oldnslow]

Quick hint (will have a little more time tomorrow) - here is bed heater config for a Duet2 board

; Heaters
    M308 S0 P"bedtemp" Y"thermistor" T100000 B4138 ; configure sensor 0 as thermistor on pin bedtemp  
    M950 H0 C"bedheat" T0                          ; create bed heater output on bedheat and map it to sensor 0
    M307 H0 B0 S1.00                               ; disable bang-bang mode for the bed heater and set PWM limit
    M140 H0                                        ; map heated bed to heater 0
    M143 H0 S120                                   ; set temperature limit for heater 0 to 120C

Need to check above against the TeamGloomy pin names for your board (e.g. Fly-E3-Pro)

Presume you are on to the Duet3D GCode dictionary for reprapfirmware.

Check out Connecting and configuring a bed heater (towards the end) in the Duet3D documentation and M303 Heater Tuning.