gpiolib: of: Move Atmel HSMCI quirk up out of the regulator comment

The regulator comment in of_gpio_set_polarity_by_property()
made on top of a couple of the cases, while Atmel HSMCI quirk
is not related to that. Make it clear by moving Atmel HSMCI
quirk up out of the scope of the regulator comment.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Link: https://lore.kernel.org/r/20250402122058.1517393-3-andriy.shevchenko@linux.intel.com
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

Author: andy-shev

drivers/gpio/gpiolib-of.c

@@ -268,6 +268,9 @@ static void of_gpio_set_polarity_by_property(const struct device_node *np,
 		{ "fsl,imx8qm-fec",  "phy-reset-gpios", "phy-reset-active-high" },
 		{ "fsl,s32v234-fec", "phy-reset-gpios", "phy-reset-active-high" },
 #endif
+#if IS_ENABLED(CONFIG_MMC_ATMELMCI)
+		{ "atmel,hsmci",       "cd-gpios",     "cd-inverted" },
+#endif
 #if IS_ENABLED(CONFIG_PCI_IMX6)
 		{ "fsl,imx6q-pcie",  "reset-gpio", "reset-gpio-active-high" },
 		{ "fsl,imx6sx-pcie", "reset-gpio", "reset-gpio-active-high" },
@@ -293,9 +296,6 @@ static void of_gpio_set_polarity_by_property(const struct device_node *np,
 #if IS_ENABLED(CONFIG_REGULATOR_GPIO)
 		{ "regulator-gpio",    "enable-gpio",  "enable-active-high" },
 		{ "regulator-gpio",    "enable-gpios", "enable-active-high" },
-#endif
-#if IS_ENABLED(CONFIG_MMC_ATMELMCI)
-		{ "atmel,hsmci",       "cd-gpios",     "cd-inverted" },
 #endif
 	};
 	unsigned int i;