E-stop stop to work correctly

[rmaltais]

Hello all,

I have a strange problem. Since I updated new firmware, my E-stop no longer has any effect and it no longer produces alarm 10. However, I can see very clearly the signal on the E software which turns red. I had to redo the configuration but I don't see what could be causing this problem. I compiled my new firmware on the WEB interface. I have a this controler:

thank

[karoria]

Do you connect Estop to reset pin? If not connect it to reset pin.

[rmaltais]

Sure it's connect. The problem is in the firmware, i change the firmware and now it's work. The last firmware did not work with my controller. Now it's work but i have an other problem with probe. The probe stay freeze after triggered.

Not very better.

[terjeio]

There was a regression in control signals IRQ handling, should be fixed now.

[rmaltais]

Ok work fine now but probe still stop after first triggered. The state of probing still always in "probing..." and no move to retract.