Digiview App Stuck at "Waiting for Video"

[mughu94]

I have been trying, unsuccessfully, to get the digiview app to work with my V2 goggles.

I have tried multiple USB C <> USB C cables 3 (all "data" cables). I have to go into my USB settings on the phone and switch from "charge only" to a full usb connection, but the app still just says "Waiting for video"

Anyone else have this problem? Any cable recommendations that are confirmed to be working?

[gonsp]

Try to disable the low power mode when the aircraft is unarmed

[tavdog]

I can't get my V1 goggles to work either. Stuck on waiting for video. Tried disabling low power mode, still no luck.

[tavdog]

Never mind, combination of lower power disable, 50mbps and unplug replug got it working.

[AndKe]

So to recap: It is incompatible with 50mbits - and low power mode?
Did you try to plug in the android device after takeoff (when it's in normal power mode)?
I really like the low-power mode, otherwise it gets very hot

[tavdog]

So to recap: It is incompatible with 50mbits - and low power mode? Did you try to plug in the android device after takeoff (when it's in normal power mode)? I really like the low-power mode, otherwise it gets very hot

For me 50mbits is required for it work. And disable low-power is also required. I have not tried to plug android in after arming though but I think that would work.

[AndKe]

@tavdog https://oscarliang.com/dji-fpv-goggles-video-out/ does mention that you can use low-power mode if you connect cable after takeoff :)

[tavdog]

@mughu94 Have you had success ? If so please close this issue.

[nikiatanasov]

I've found it works with low power mode ON, but to get the picture after takeoff the usb cable must reinserted and the picture shows up.

[Dunsteer]

I dont know if it is possible to retry the video automaticali from the app without the need for reconnecting after arming the quad?

[jlucidar]

I dont know if it is possible to retry the video automatically from the app without the need for reconnecting after arming the quad?

If I remember correctly, It's a limitation on the DJI goggles side.
When no feed is displayed, the app is still trying to communicate with the goggles at regular interval. We can't do much more, and the connection needs to be physically 'reset' to get the video feed stack on DJI side reinitialized.

[Dunsteer]

I tried resetting it and nothing happened. That's weird. Does it have something to do that I am using O3 with goggles V2?