Hi, ds_twr_responder doesn't work

[ycpiglet]

I'm using PCA10056 board and the basic example worked.
But when I flashed ds_twr_responder, it didn't work.

Where I found the error is the below part.

if (ret == DWT_ERROR) { LOG_INF("Error"); continue; }

I also read the Note 11 which you wrote but I don't understand what I do.
Please let me know. My address is 'ycpiglet@gmail.com'

[foldedtoad]

I am looking into this issue... will get back when I have further information.
This appears to be the only usage of dwt_starttx(DWT_START_TX_DELAYED | DWT_RESPONSE_EXPECTED);

[ycpiglet]

Oh, I solved the problem by modifying the values of DELAY such as POLL_RX_TO_RESP_TX_DLY_UUS.

However, I still don't know why it happens even though it is correct mathematically.

So it is quite tough to change manually and successively until it's fine.
I'd rather use ss_twr than ds_twr cause the former is more simple(the less number of values to modify).

[Gary-zzy]

Oh, I solved the problem by modifying the values of DELAY such as POLL_RX_TO_RESP_TX_DLY_UUS.

However, I still don't know why it happens even though it is correct mathematically.

So it is quite tough to change manually and successively until it's fine. I'd rather use ss_twr than ds_twr cause the former is more simple(the less number of values to modify).

Hi, I am also doing with this sample and stuck in these delay issue. If it is possible, could you please share me with the delay you have set? Thank you so much!