Release 0.0.7

[amirna2]

RadioMesh v0.0.7 Release Notes

Initial Release

First release of the RadioMesh library providing core mesh networking capabilities for LoRa-enabled ESP32 devices.

Features

• Multi-hop mesh networking using LoRa
• Signal strength based adaptive routing
• Support for ESP32 boards (tested on Heltec WiFi LoRa 32 V3, Seeed XIAO ESP32 WIO-SX1262)
• Support for Heltec CubeCell (tested on Heltec CubeCell v2)
• Device Builder pattern for easy configuration
• Optional OLED display support
• Optional WiFi capabilities (client and AP modes)
• Basic security with AES encryption
• Local storage using EEPROM

Supported Hardware

• Heltec WiFi LoRa 32 V3 (primary development board)
• Seeed Studio Xiao ESP32 + WIO-SX1262
• Heltec CubeCell Board V2

Dependencies

• Arduino ESP32 core
• RadioLib (for LoRa radio)
• U8g2 (for OLED display)
• ESP Async WebServer / AsyncTCP
• micro-ecc
• Crypto

Getting Started

See the Wiki for:

• Getting Started
• Architecture Overview
• Device Configuration Guide
• Protocol Specification

Known Limitations

• Device inclusion protocol partially implemented
• Maximum 7 hop network depth
• Route table limited to 10 entries

---

This discussion was created from the release Release 0.0.7.