Carelink follower: Response code 400

[josziglimp]

Hi, we were just days ago switched from Libre sensor to Medtronic's 780 pump and sensor. I would very much like to continue using xDrip and Nightscout, however I keep getting the CareLink download error! Response code 400 message.

Using the 01.31 nightly build. Login to the US carelink server worked.

Any suggestions?
Thanks

[Navid200]

@benceszasz Was this ever fixed?

[josziglimp]

With the stable release of xDrip I couldn't even log in.
With the 01.31. nightly version, at least the login to CareLink worked, but not data download.

@benceszasz Bármilyen megoldás érdekel, csak folyamatosan ki tudjam nyerni az adatokat vagy a pumpából vagy a CareLink-ből. Köszi!

[benceszasz]

@josziglimp Are you in the US or outside US?

[josziglimp]

My D son is in the US, and he is using the Medtronic US server. I'm in Hungary.

[benceszasz]

As I wrote in the email, it seems to be the same problem as with another US user: the US also needs to switch to the new v11 data endpoint. Similar issue:
#3855 (comment)
Since the new test version, which uses the new v11 endpoint in case of US too works fine, I have created a new pull request for this change:
#3888
Hopefully it will be soon approved and after that it will part of the next nightly build.

[benceszasz]

@josziglimp
I have just installed the 01.31. nightly version on a test phone, set the country, logged in with a dedicated care partner account and everything is working fine. Do you use a patient or a care partner account? If you use a care partner account do you use it in also in the official follower app (CareLink Connect)? Have you used the patient account with standalone Medtronic sensor before you started to use the pump?
Below a screenshot of this fresh install:

[josziglimp]

I'm using a dedicated care partner follower account.

Although the official CareLink Connect app is also acting up on my phone in the sense that every single time I open the app I have to choose server, log in and go through all the acknowledgements as if I'm starting for the first time ever. (For the CareLink app I'm using another dedicated CareLink partner follower account.) I'm not sure if this has to do with logging in to the US server from Hungary.

Previously we used Libre sensors and with that xDrip worked beautifully (although without pump data).

@benceszasz I assume your the account that you use above is not in the US. Would you be able to test with my US account? How can I get to you the login info? Thanks

[benceszasz]

@josziglimp we can discuss the US account in private. Please write to my carelinkfollower at gmail.com email address.