Skip to content

Building Kong on s390x

Jump to bottom
Carole Corley edited this page Oct 22, 2020 · 25 revisions

Building Kong on s390x

The instructions provided below specify the steps to build Kong version 2.1.4 or Kong 'next' on Linux on IBM Z for the following distributions:

  • Ubuntu (18.04)

If you do not need a custom build of Kong on s390x, you may opt for the multi-arch alpine docker image docker.io/linuxforhealth/kong:2.1.4 which supports amd64, arm64 and s390x.

General Note: When following the steps below you will need access to the docker command and may therefore need to sudo su.

Step 1: Build Kong

1.1) Set up build environment

1.2) Set OpenResty version

1.3) Set your docker repo

1.4) Build Kong apk

1.5) Build Kong alpine image

Step 2: Test Kong (Optional)

2.1) Run all test cases

References:

The information provided in this article is accurate at the time of writing, but on-going development in the open-source projects involved may make the information incorrect or obsolete. Please open an issue in the LinuxForHealth/kong-build-tools repo if you have any questions or feedback.

Clone this wiki locally