I am getting an No moonraker connection after installing Moonraker and Fluidd

[dbjones-clanjones]

My first attempt at using the Creality Help Script on my Creality K1 had this same issue, but I had installed lots of things before testing so I wasn't sure if I had broken something with what I had done. So eventually uninstalled everything and followed the instructions to Reset Factory Settings.

After going through the process of accepting the T's & C's for Root and getting the root username and password, I started by installing just:

1. Moonraker & Nginx
2. Fluidd
3. Entware
4. Klipper Gcode Shell Command

However, when I go to the Fluid Page I get the same error:

No moonraker connection. Please check moonraker status and / or refresh.

I went and got the following items for diagnose:

1. Error Message displayed in Fluidd
   

2. Showing what was installed
   

3. What is Shown on the System Menu
   

4. Results of forcing restart of Moonraker
   

After I initiated a forced Moonraker restart, Fluid now seems to work ok.

Could this an issue be with the initial installation of the Moonraker and Nginx or is related to a relatively recent update to the firmware I had to do before I started the rooting process?