K1 Max back fan stays ON after print ends

[pavlicekdavid]

Hi, after I installed Fans Control Macros from Helper Script on my K1 Max and set up cooling settings in Orca like its in manual, back fan (fan1) always stays on at 82% after print and never turn off (wait all night).

Does someone know how to repair it?

Thank you.

[d3dorsett]

I have the same issue. The command M107 P1, should turn it off.

I have noticed in gcode_macro.cfg, the command is sent under [gcode_macro END_PRINT]. It appears to turn it off, then a few seconds later something else turns it back on and leaves it running.

[gcode_macro END_PRINT]
gcode:
Qmode_exit
EXCLUDE_OBJECT_RESET
PRINT_PREPARE_CLEAR
M220 S100
SET_VELOCITY_LIMIT ACCEL=5000 ACCEL_TO_DECEL=2500
TURN_OFF_HEATERS
M107 P1
M107 P2
END_PRINT_POINT
WAIT_TEMP_START
M84

[buildjournal]

Bumping this up. @Guilouz
I had the same issue for a few months now. Back fan stays on after print. Maybe around 5-10% power. Would like to know how to automatically turn off.