Create PZ Probe.cfg

config/hardware/probes/PZ Probe.cfg

@@ -0,0 +1,55 @@
+[gcode_macro _USER_VARIABLES]
+variable_probe_type_enabled: "vorontap"
+variable_startprint_actions: "bed_soak", "extruder_preheating", "chamber_soak", "clean", "tilt_calib", "z_offset", "bedmesh", "extruder_heating", "purge", "clean", "primeline"
+gcode:
+
+# TAP probe definition also include the probe management macro directly from here
+[include ../../../macros/base/probing/generic_probe.cfg]
+# 
+[probe]
+pin: ^PROBE_INPUT
+x_offset: 0
+y_offset: 0
+z_offset: 0
+speed: 5
+lift_speed: 10
+samples: 3
+samples_result: median
+sample_retract_dist: 1.0
+samples_tolerance: 0.005
+samples_tolerance_retries: 3
+
+#pz probe settings with preset 1 selected on the pz board. I selected the voron tab somehow its working very well here. 
+[probe] 
+pin: !toolhead:PROBE_INPUT
+x_offset: 0
+y_offset: 0
+#z_offset: 0
+speed: 6
+#lift_speed:30
+samples: 2
+samples_result: median
+sample_retract_dist: 2.0
+samples_tolerance: 0.01
+samples_tolerance_retries: 15
+activate_gcode:
+    G4 P200  # Wait 200ms
+    {% set PROBE_TEMP = 150 %}
+    {% set MAX_TEMP = PROBE_TEMP + 5 %}
+    {% set ACTUAL_TEMP = printer.extruder.temperature %}
+    {% set TARGET_TEMP = printer.extruder.target %}
+
+
+    {% if TARGET_TEMP > PROBE_TEMP %}
+        { action_respond_info('Extruder temperature target of %.1fC is too high, lowering to %.1fC' % (TARGET_TEMP, PROBE_TEMP)) }
+        M109 S{ PROBE_TEMP }
+    {% else %}
+        # Temperature target is already low enough, but nozzle may still be too hot.
+        {% if ACTUAL_TEMP > MAX_TEMP %}
+            { action_respond_info('Extruder temperature %.1fC is still too high, waiting until below %.1fC' % (ACTUAL_TEMP, MAX_TEMP)) }
+            TEMPERATURE_WAIT SENSOR=extruder MAXIMUM={ MAX_TEMP }
+        {% endif %}
+    {% endif %}
+
+[stepper_z]
+endstop_pin: probe:z_virtual_endstop