Wiring to intercom

[nomad-debugger]

Would it be possible to show how this is wired into the intercom? If I have my two L wires going into the intercom, how do I put the bridge in between? I'm not familiar with the connector that's on the bridge.

Coming off of an Nuki Opener and otherwise not at all familiar with the hardware side of things, this would be a massive help. Many thanks in advance and apologies for what is probably a dumb question.

[alexdetsch]

Are you sure, that your intercom really runs on simplebus2? The Nuki Opener isn't compatible with simplebus2, so it shouldn't have worked with your intercom. This project only works with Comelit simplebus2 intercoms.

Regardless, just put two extra wires (~5cm each) into the WAGO (red/black) connector. Then connect those to the clamps on the intercom on the L pins where already 2 wires from the wall should be connected. As the bridge is agnostic to polarity, it's not important which goes where. The wires from the wall have to stay in as well, don't disconnect them.

[nomad-debugger]

Thanks for the response, @alexdetsch! Yes, I am sure that the intercom uses simplebus2. I should have phrased this better, but my previous intercom was Nuki Opener compatible. My new one is a Comelit and I found this project in search of a Nuki Opener replacement.

Thanks for sharing the instructions, this seems extremely straightforward. I think I got thrown off by the number of entry points on the connectors. This clears it all up :)