Servo frequency default 1000Hz #43
Unanswered
NotIllusion2000
asked this question in
Q&A
Replies: 0 comments
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Uh oh!
There was an error while loading. Please reload this page.
-
Is it correct, that the Servo frequency defaults to 1000Hz? At that frequency a servo can't be controlled since the signal needs to be at least 2,5ms long for proper decoding, the on cycle is maximum 2000us long. Next thing is that if I set frequency to 50Hz ( myservo.setFrequency(PIN_Thr, 50); ) it still is 1000Hz, measured with an oscilloscope. The debugger shows 50 Hz. If I set 250 or 400Hz everything works. Is it my error or is the code not correct?
Beta Was this translation helpful? Give feedback.
All reactions