Panadapter - Set SDR++ to Rig's 1st IF

[gbeyer3]

Hi, I'm planning to connect my rig to an RTL-SDR/computer (linux) to create a panadapter for my radio. I need to set the software to my FT-950's 1st IF, which is 69.45MHz. Is there a place I can set this in SDR++? As this is an edge case, if the UI doesn't support it, I'm willing to tweak a config file if necessary. Thanks much!

[cu]

I have the same issue. My radio is tuned to 7.2 MHz and my panadapter hears the same signal at 64.4534 MHz. I have "offset tuning" enabled, "Offset mode" to manual. But any offset that I enter does not seem to change the displayed frequency or indeed anything in at all.